Suspended support trolley
This boot washer is suitable for everyday muddy boot washing.
Made in polyethylene resin, it is pre-fitted with:
-one water inlet tap with 15/21 flare end piece for Ø 19 mm pipes, mounted on a stainless steel housing;
- 1 Venturi air intake system for the suction of a disinfectant;
- 1 stainless steel support and handling handle;
- water spray located between the lateral brushes and jet over the bottom brush for optimum washing;
- 4-blade galvanised steel scraper;
- 4 reinforced ground fastening points for durable installation.
This boot washer is availabale in 2 versions for a perfect cleaning.
It has two drain holes under the brushes and 1 Ø 90 mm drain hole under the scraper.- Length
- 675 mm
- Width
- 440 mm
- Height
- 990 mm
- Packaging
- No packaging
- Sales unit
- Unit
10 other products in the same category:
